Hi again
I've run out of ideas trying to get the servo motor running as a spindle.
The servo driver is set up to work in Speed mode using the 0-10v analog output from the MB3
The servo motor runs as expected when using Jog mode etc. directly from the servo driver but I cannot get any output when trying to control it via Mach4 etc.
I have 3 relays being controlled from the MB3 for, spindle enable, CW and CCW rotation.
Checking my wiring, I'm getting a 0 to 10V signal at the driver and well as the spindle enable etc. outputs.
I think I've followed the details in the driver manual but as this is the first servo I've worked with I may be completely off the mark.
I've attached the manual for the servo driver.
I'd appreciate any assistance.
Cheers
Phil