I just switched off, and when I started it got the error message that says "plc is stopped, and when I start it it says
"Plc sequences
Wrong data in ram"
I/O setup data is corrupt
Output boards are not enabled
And
RSINTRF_I_GET_REG_BY_NAME ERROR (X20) ERROR $1005
<Confirm>
Then
"Fasic
Parameters not valid (17,20)"
When I try to get in "Manual Movements"
It says
"HANDLING
Parameters not valid"
Or in PLC Sequences too
Or in Editor it says
"user unrecognized"