587,787 active members*
2,359 visitors online*
Register for free
Login

Thread: 11m control Z axis

Results 1 to 3 of 3
  1. 09-06-2010, 07:09 PM #1
    wildhorsemfg
    wildhorsemfg is offline Registered
    Join Date
    Apr 2009
    Posts
    40

    11m control Z axis

    I bought a used cnc mill with a fanuc 11m control on it
    it was working fine until this morning , and now the z will not move
    limit switches not tripped , all lights on all boards are green , no errors

    , the tool changer is non working , but i will check to see if it settled and is tripping a switch ...
    any ideas ?
    cody
    www.wildhorsemfg.com machinist / gunsmith
    accumax with Fanuc 11M , Hitachi seiki 3NE with 6T
    Reply With Quote Reply With Quote
  2. 09-07-2010, 12:56 AM #2
    wildhorsemfg
    wildhorsemfg is offline Registered
    Join Date
    Apr 2009
    Posts
    40
    problem fixed
    tool changer settled and was off a limit switch
    but there was no errors ... was a strange problem
    cody
    www.wildhorsemfg.com machinist / gunsmith
    accumax with Fanuc 11M , Hitachi seiki 3NE with 6T
    Reply With Quote Reply With Quote
  3. 09-07-2010, 01:17 AM #3
    Al_The_Man's Avatar
    Al_The_Man
    Al_The_Man is offline Community Moderator
    Join Date
    Dec 2003
    Posts
    24220
    That error would have been the responsibility of the MTB to place a message in the control, they probably missed or overlooked that one.
    Al.
    CNC, Mechatronics Integration and Custom Machine Design

    “Logic will get you from A to B. Imagination will take you everywhere.”
    Albert E.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. VQC 15/40 4th axis with M2 control
    By jimiscnc in forum Mazak, Mitsubishi, Mazatrol
    Replies: 5
    Last Post: 10-29-2009, 03:14 PM
  2. Cs axis control
    By guhl in forum Fanuc
    Replies: 5
    Last Post: 05-14-2009, 11:48 AM
  3. Rotation control help on A axis
    By Art Ransom in forum DIY CNC Router Table Machines
    Replies: 27
    Last Post: 09-23-2006, 01:04 PM
  4. How to control 8 axis?
    By lepton in forum CNC (Mill / Lathe) Control Software (NC)
    Replies: 2
    Last Post: 08-20-2006, 03:35 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules