Please bear with me, as I am entirely new to the CNC world. I bought a Partner 1 recently, to manufacture parts for by custom pistol business. I am trying to teach myself how to run this machine, and have only had it powered up for a couple days so far. I have noticed when ever I try to open an existing conversational program, or start a new one, I get an error 154. I then have to restart the machine to do anything. The screen says CRC error in data, diskette is bad or not formatted. I have been able to enter parametric text programming and run it. It was a short engraving program I did just to try it. After running it, I saved that program to the floppy with no problem.
A little bit about my controller that has me a little stumped as well. It is a Centurion V, and on the info screen after the Centurion V it says 5.76. Lower on that screen it reads MS - DOS 6.22, which I've read wasn't used on the 5, only the 6. Also, I have no simdisk card, rather a 1GB hard drive that looks to have been added at some point.
Any advise on getting the conversational working, or just shedding some light on what I may have going on with this hard drive, would be appreciated