hi everyone
im victor,i new here
i have a citizen m-32 lathe and it has an ERROR
OVER VOLTAGE ERROR. the lathe sometimes work fine, but after 10 minutes the alarm appearrs again
help me please
hi everyone
im victor,i new here
i have a citizen m-32 lathe and it has an ERROR
OVER VOLTAGE ERROR. the lathe sometimes work fine, but after 10 minutes the alarm appearrs again
help me please
You have a short on the 24v dc this is normally the wire to the X2 brake clear any swarf from this area long term the cable will need attention
Hello yes the power supply alarm is a problem on the drive you can send me a photo