I am new here, not sure this is the correct category, but I have a problem...
My machine repair guy left my O9xxx macros unlocked on my Toyoda FH-55, my laptop (that had my backup programs) got a virus and had to have the OS re-loaded, and my night shift operator deleted ALL my files in the control memory.
My tool change program was O9000, and was registered, so I cannot call a tool without it, I can run an M6 tool change, but it just changes from tool zero to tool zero.
Does anyone have a quick solution? A copy of a tool change macro would be helpful, I could write one, but just don't know what parameter I need to be able to tell the control what tool it is supposed to go get.
I know this is a stupid problem, and I should have had another backup, as well as a hard copy, but I have jobs that need to ship (After I re-program them)
Any help would be greatly appreciated!!!!!!!!