Originally Posted by
mikevee
Hi guys,
Was hoping any one has encountered problem like this before.
I'm using Anilam 3300M controller with an old NUM pulser.
I've got the pulser working, but I cannot control the XYZ axis.
I can select it on the menu, but the axis doesn't actually change, just stays in X all the time no matter what I select. But when I do select DISABLE, the handwheel option goes off ...
I'm thinking maybe something to do with the software ?
Also, on the 3300M, the handwheel goes to one of the two CTR ports, which is a 9 pin connector.
any ideas ?
Thanks in advance,
Mike