How do you get Mastercam (X3 lathe) to output I & or K instead of R? I'm guessing its in the control definition but I haven't been able to find it.
How do you get Mastercam (X3 lathe) to output I & or K instead of R? I'm guessing its in the control definition but I haven't been able to find it.
Look under Arcs:
I saw that but didn't think it was what I needed because it said XY instead of XZ. Anway, thanks again.
That is the chuckle for the day for MasterCam users. An obvious mistake in programming the GUI.