hi,
i have entered parameters for puma 10s machine, and have this status "not ready". the manufacturer doesn't have a complete list. may be i still need more parameters, who can help me? who is familiar with fanuc otc controller .
best regards
hi,
i have entered parameters for puma 10s machine, and have this status "not ready". the manufacturer doesn't have a complete list. may be i still need more parameters, who can help me? who is familiar with fanuc otc controller .
best regards
When you press the button requesting Machine Ready, what happens?
1. If nothing, press and hold the ALARM RESET button and also press the Machine Ready button.
a. If still "nothing happens" check all E-Stop and its wiring.
b. Possible issue with the <Machine Ready> or <ALARM RESET> buttons.
2. If <Machine Ready> flashes and turns solid, but turns off when <ALARM RESET> is released, then you are in OVERTRAVEL
3. IF <Machine Ready> flashes for 5 seconds and then turns off, the phase is backwards.
Doosan Service Technician
[email protected] O:973-618-2461 M:973-803-9479
thanks my friend,
have you got the files i have attached in the previous thread?. but i didn't try to press ready button, is it clear button to catch ?
i will try these procedures and inform you what will happen
do you think that the entered parameters are sufficient and their values are true?
by the way, the spindle drive status is ready as it shows 000000, and the pump work after seconds from the power on.
thanks again for your collaboration
best regards
hi, i have conducted the procedure you have sent, at the beginning, no lights appear on the ready button, there is a 2 7-seg digits, it shows 01 , i checked the emergency switch, there was no 24vdc at normally open state and no changes at the diagnostic or ladder pages , i tried to catch the second sensors that i think are connected serially, i didn't find them. finally i made a short circuit between the 24n and EMT wire inside the cabinet , which i think it is the equivalent for the emergency switches. then i tried to push the ready button, it lights all the time as flasher , even if i press alarm reset, the not ready state still flashes,
the 7-seg digits, shows 12, when i press ready it gives 7.
best regards
so, what do you think the problem,
btw, when i tried to change phases, the pump didn't work.
best regards
sir,
please do you have any answers?