Alright CNC gods, I need some suggestions, I have a large amount of 80/20 rails from a failed project. Looking to turn those into a cnc/plasma table. I lots of rails, TONS of fasteners, enough steppers and electronics to build a killer robot and the space for a 8x4 or 4x10 table.

I have the following 80/20 parts, willing to cut what is needed but would like at least an 8x4 table out of this, or will buy some to extend to make 4x10.

1503-LS x6 105”
1503-LS x5 10”
1503-LS x10 57”
1517-LS x2 105”
1517-LS x4 96”
1517-LS x2 57”
1545-S x6 78”
1530-ULS x2 100”
1530-ULS x3 52”

4441 x4
4352 x12
4302 x142
4340 x2
14117 x4
3778 x300
3943 x24
3941 x250
2826 x50
3910 x40
13-3940 x80
3663 x36
14161 x36
Bunch of openbuild v-slot wheels, bearings.


Now I would like to not spend another arm and leg to make this as I have about 4k into the above parts, I have about a grand set aside for the cnc and torch. I have NEMA 23s, power supplies and drivers for all. My goal with this project would be to have a cnc/plasma table with switchable head between torch and spindle, I would also like direct drive control. Thanks for your time and effort any any help you can provide.