[togr]

Hello.

I am new at this forum. My english isn't wery good, but i understand what i read.
I have a two questions i hope somone can help me with. I have just canged work
. I have
for the most run heidenhain controll for 15 yers. And a litle fanuc. At my new work i have
a machine with an old fanuc style controll. I realy miss boremilling at heidenhain
. My machine can not run x y and z in the same block. Do enybody have a clue how
to do boremilling? The next question is that the controll has wery litle memory. A I am working a mastercam but the program is to long. I think i can write ca 600 lines. Do
someone have an selution for that prolem. Run straigh from computer? How do i do
that.
I hope for some god answers even if my english is bad.

[Al_The_Man]

What is the Fanuc controller 0, 6, 10,?
Al.

[togr]

Thank you for answer.
I realy don'n know the type. I can check in the morning.
Do you know how to find out? I don't have any instructions documents i think.

Tommy.

[togr]

The machine or controller name is yasnac J50M.

[356911914]

see if there are any useless programs stored in memory that could be taking up space. delete them

[landslide1]

on the 0m-B G76 (fine boring cycle) g85-89 are other boring cycle variations. I'm not sure how universal these codes are across the fanuc controls.
you may be able to read about them here FANUC Series 0-MB, FANUC Series 00-MB OPERATOR'S MANUAL