Just started at a new shop we have a Daewoo Pumma 8s Lathe with a Fanuc OT, im trying to post from OneCnc To the Machine, What screen does the Lathe need to be in to read the post, Thanks Sam
Just started at a new shop we have a Daewoo Pumma 8s Lathe with a Fanuc OT, im trying to post from OneCnc To the Machine, What screen does the Lathe need to be in to read the post, Thanks Sam
Program screen, and MDI or Edit mode. Find the Yellow Fanuc books, they will spell it out.
Tryed That It says "error setting:COM2" on OneCnC, we do not have any Yellow Fanuc books
That error is on the PC side, not Fanuc.
ok thanks
If you'd like, I have Doosan/Fanuc communications books as well as setup/programming manuals. What year/serial#?
Serial is pm8s0127
ok now im getting the program to send, but i cant find it on my Lathe, im in program, and edit mode, then if i hit the Read button i get a alarm code 86
SP,
Try the directory screen. Go into edit and push "DIR"
Also make sure tha there is a "%" at the end of the program - after the M30.
Alarm 86 is usually the Hardware handshake is not seen.
It is usually best to use a 3 wire cable with the H.H. jumpered out.
What is the Fanuc model?
Al.
CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.