[Javier29]

Hi! My english is not veriy good but I going to try explain my problem. I want to do a lineal not interpolation with Mach3. Because so, my stepper motors will go faster than now. I think that there will exist any instructions in G-Code that I can do it or any option in Mach3. Therefore, each stepper motor will move to its velocity.

I thank you and I apologize for my English.

[Al_The_Man]

I think you are referring to the original way of using G00, this was originally done in a non interpolated fashion, but most controllers now will implement G00 in a interpolated move, the same as G01, but at rapid.
Al.

[Javier29]

Yes, I refer to the original way of using G00. Then, I do not know how do a not interporlated move with Mach3. Is there any way to make not interpolated movements in Mach 3?

Thank you Al_The_Man

[Al_The_Man]

Not as far as I know, two separate G00 moves? but that is not quite how it was originally performed.
Al.

[Javier29]

ok, thanks you, but I have worked with other pick&place and moves not interpolated are possible.

[JEST]

I don't think Mach3 allows for it. Some controls will move as you are asking. I know Fadel and Fanuc controls move this way by default. (dog leg rapids)
The only way I know to get the motion you are looking for, is to create the path... rapid both axis to junction, second move will be full rapid for axis remaining..

[Javier29]

OK, I will try the next day. Thanks you