Machine is a SL-0H w/ Fanuc 3-T control. When I press the spindle forward button in jog/handle mode nothing happens. In MDI mode with s500-> m3->start, the cycle start LED turns on but spindle still doesn't spin. i have the ladder diagram and it lists address 48.0 as the 'spindle forward (output)' and that turns to changes to 1 after the spindle forward button is pressed, so i assume that all the conditions for the spindle to start have been fulfilled? no alarm codes on the control or the spindle drive. any ideas of what else i should check before calling a tech to come out?