603,893 active members*
3,790 visitors online*
Register for free
Login
IndustryArena Forum > CNC Electronics > Stepper Motors / Drives > ST-M5045 Stepper Motor Driver

Thread: ST-M5045 Stepper Motor Driver

Results 1 to 3 of 3
  1. 04-03-2015, 03:58 AM #1
    ononno
    ononno is offline Registered
    Join Date
    Feb 2015
    Posts
    5

    ST-M5045 Stepper Motor Driver

    HI Everyone,
    I need your opinion about ST-M5045
    Its looks more better then M542,2M542 drives.
    But not sure about it.
    Reply With Quote Reply With Quote
  2. 04-03-2015, 06:36 PM #2
    James Newton
    James Newton is offline Registered
    Join Date
    May 2005
    Posts
    1397

    Re: ST-M5045 Stepper Motor Driver

    If it comes from China pre-built at low cost then I don't trust it. Period.
    James hosts the single best wiki page about steppers for CNC hobbyists on the net:
    http://www.piclist.com/techref/io/steppers.htm Disagree? Tell him what's missing! ,o)
    Reply With Quote Reply With Quote
  3. 04-05-2015, 06:13 AM #3
    ononno
    ononno is offline Registered
    Join Date
    Feb 2015
    Posts
    5

    Re: ST-M5045 Stepper Motor Driver

    I dont get any bad review about this driver. I want to play with it. Will order soon and post my update here.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. UIROBOT:stepper motor,linear stepper motor and stepper driver Yahoo Group
    By uirobot in forum Community Club House
    Replies: 0
    Last Post: 02-26-2013, 08:37 AM
  2. Power Supply for 4 Stepper Driver 32-65VDC and 4 Stepper Motor 65V 2.3A
    By guy2b1 in forum DIY CNC Router Table Machines
    Replies: 16
    Last Post: 03-08-2011, 12:50 PM
  3. 6 leads stepper motor connect to TB6560AHQ stepper driver board
    By wf1318 in forum Stepper Motors / Drives
    Replies: 2
    Last Post: 07-25-2010, 08:19 AM
  4. Integrated stepper motor? with built-in stepper motor driver
    By uirobot in forum News Announcements
    Replies: 0
    Last Post: 06-07-2010, 09:59 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules