[pyrofx1]

I have search my fingers offto no avail.
I have a mill with a dead control. When switched on , the windows 95 controller boots and ends up at the screen that asks you to enter 3 for safe mode. None of the soft touch keys select or do anything. The keyboard that is attached doesnt do anything either.

Am I SOL , or is there any other system that can use the scales and servos. Its hard to imaging this is a 2000 # piece of junk now. The mill only has about 600 hours on it.
Thanks for any help,
Greg

[Mica_Bruce]

I have search my fingers offto no avail.
I have a mill with a dead control. When switched on , the windows 95 controller boots and ends up at the screen that asks you to enter 3 for safe mode. None of the soft touch keys select or do anything. The keyboard that is attached doesnt do anything either.

Am I SOL , or is there any other system that can use the scales and servos. Its hard to imaging this is a 2000 # piece of junk now. The mill only has about 600 hours on it.
Thanks for any help,
Greg

Have you had any success with repairs?