Hi folks.
I'm a new member and have just got started with my laser.
My machine is a Redsail X700 from eBay 700mm x 500mm work area.
I have to say some of the engineering leaves a lot to be desired, but for the money, I really couldn't expect better I suppose.
The manual for the controller is the usual Chinglish, and hard to read, I really wish these companies would spend a few quid (pounds) on getting a decent interpreter. Haha!
Any way, here's my first question for anyone with the same or similar machine. On initial turn on the origin was set at back right, but somehow whilst playing, I seem to have changed it. It's still back right, but not quite as far back and slightly left of where the original origin was. I can't make any sense of the manual as regards resetting it. Any ideas? Below are a couple of pics for machine and controller
Cheers.
Andy.