[ward2699]

so i decided to try to build one of these things...cnc plasma. i honestly am not sure if i have the correct components so i will list them and please someone respond..lol
probotixs 35 volt power supply with breakout board and sidestep drivers
i am running keling 425 oz motors

will this combo work (i hope i already bought them)

[keldanmedia]

Best answer? Contact the vendor, assume you bought everything from Probotix. Ordering parts requires a CC. Ordering the correct parts and configuring them properly will require a basic understanding of high/low voltage electricity and electronics (among many disciplines). I mention this because if you had the basics, you would likely not have to ask your question or you would have posted the necessary information required to intelligently answer your question.