Ello.

I got some fairly cheap CSMQ-04BH 400w servos, as well as some CSDj-04BX drives and I've only managed to find information on the drives (OEMax manual).
Currently in the process of organising wiring and the OE manual specifies which pins to have connected to the encoder, but I'm not certain on which they are on the encoder.


They came with pre-wired cables but I'm not certain they are correctly wired. A diagram would help instead of checking each pinout on the connector (3M 10320) and hoping they are correct for the motor.

Would it be safe to assume the pinout below for CSMQ drives is correct IF: the pinout for Bat+,- and grnd match the pre-wired cables?
http://www.cnczone.com/forums/attach...d=331972&stc=1

In the case that the CSMQ requires 15 pins is it safe to connect all 15 to the driver, or rather only the 9 that the drive calls for?
http://www.cnczone.com/forums/attach...d=331974&stc=1


Thanks for any help, I yet have so much to learn.
~ Jay.