Hello
I managed to cutt with my new X-700- but everything is cutting and engraving from the back side -that means everything is mirrored. Where can set this feature?
Many thanks Marc
Hello
I managed to cutt with my new X-700- but everything is cutting and engraving from the back side -that means everything is mirrored. Where can set this feature?
Many thanks Marc
Nobody can advise you specifically due to lack of specific information such as controller make and model number, software being used, etc.
"80 Watt” 700mm x 500mm Ke Hui 7050 Laser (Similar to the Red Sail)
Try this 2 minutes video, hope will help:
https://www.youtube.com/watch?v=ydW8a9jgYGk
Polish @ Éire