[abadade]

Hello
I have a FANUC SERIES O-T with not ready problem and after seen the ladder I saw that F148.6 bit cause this problem but I don't know what's mean this bit ?

[STLMachinist]

F148.6 "SA" is the servo ready bit from the control to the PMC. Your servo's are not ready. The machine could be in Emergency Stop, or an axis could be on a hard limit switch, or there could be a "Machine ready" switch of some sort that needs to be pressed for that bit to be triggered by the servos. Other issues could be the problem also.

In short, your servos are not ready.

[abadade]

F148.6 "SA" is the servo ready bit from the control to the PMC. Your servo's are not ready. The machine could be in Emergency Stop, or an axis could be on a hard limit switch, or there could be a "Machine ready" switch of some sort that needs to be pressed for that bit to be triggered by the servos. Other issues could be the problem also.

In short, your servos are not ready.

Thank you for your help