Hello,
I am thinking of buying a K2 or other small router for cutting 3.2mm aluminium. Does anyone have any recomendations? I am not planning on doing production work, I just need to make prototype parts to speed up the design to release cycle. I would especially like to hear from anyone in the Glendale-Phoenix area.
Thank you.
Roger
Thread: K2 router in Arizona?
Results 1 to 2 of 2
-
08-02-2007, 05:44 PM #1
Registered
- Join Date
- Sep 2005
- Posts
- 13
K2 router in Arizona?
-
08-03-2007, 01:44 PM #2
Registered
- Join Date
- Dec 2006
- Posts
- 31
Roger,
This forum doesn't see a lot of action. You might have better luck finding a person in your area by contacting K2 directly. They might at least pass on your email address to a few customers. I have the 3925 and it works great for extremely hard woods, but I haven't cut any aluminum yet. However, I did accidently rout right through a steel nut one time with no problem at all.
Reply With QuoteSimilar Threads
-
Father is traveling to US Arizona...
By Konstantin in forum Community Club HouseReplies: 0Last Post: 01-19-2007, 11:29 PM -
Yuma, Arizona someone to shoot the breeze with
By JohnnyYuma in forum Mentors & Apprentice LocatorReplies: 1Last Post: 11-09-2006, 05:36 PM -
Using a router for the 1st time. Need advice of cut speeds, router bits etc.
By Apples in forum DIY CNC Router Table MachinesReplies: 19Last Post: 09-23-2006, 09:33 PM -
Tucson, Arizona
By Nonoriginal in forum Mentors & Apprentice LocatorReplies: 20Last Post: 09-24-2005, 01:00 AM
Posting Permissions
