Greetings.
I have an older (1993) VF1. I had a small electrical problem with a blown tantalum capacitor (fixed) but now my cutter diameter and wear offset register has gone wild. There must have been a quick interruption of the memory power as my stored programs were all lost and the offset register had somehow entered some rather large numbers. Well, I got all of the numbers back to 0.000. The issue is that some of the 0.000's are + and some of them are -. This sets up all kinds of issues when manually entering dimeter and wear offsets. The 0.000's that are + work fine. The one's that are minus act in revers. add .0050 to one of the minus 0.000's and you get an offset of 999.9959. Not ,005. So my question is, how do I change the -0.000's to +0.000's?
Thanks in advance
Bruce Mowbray
Springville, PA USA