[smts]

I am attempting to hook up RS-232 on an Integrex 40...with a T32-3 control. I have made up the cable..set " I " parameters. before I even plug the cable in and try to send or recieve a program, I get either a 515 error cmt misconnection or a 544 tape reader misconnection error, and then the same thing when I plug the cable in. Anyone have any recommendations to fix this problem Thanks in advance

[WayneHill]

What serial wire configuration are you using?

[smts]

mazak (25 pin) pc (25 pin )
1-------------------1
2-------------------3
3-------------------2
4-------------------5
5-------------------4
7-------------------7

I get the error even when the cable is not plugged in...

[WayneHill]

How about wires 6 8 and 20? Are you shorting them together on both sides?

[smts]

yes, on the mazak side, jumpered 6-8 and then to 20 on pc side...

[alejorestrepo85]

i have the same problembut i´m using the following cable:

pc 9 pin CNC 25 pin
2--------------2
3--------------3
7--------------5
8--------------4
5--------------7
jump 6, 8, 20 on CNC side only

I want to drip feed a long problem. Can someone help me?

[carlos9ibarra]

i have this configuration in a picture, i hope this can be use.

if you want write to my e-mail and i send you the picture to your mail.

[email protected]

[camiloorduz]

Hi, did you got the connection running properly?