We have a 04 Hyundai-Kia Superturn 10 with Fanuc Oi-TB control. Had the power go out the other day when running it and when everything came back on started machine up and everything was good for about 10 minutes. The screen had nothing but lines on it so figured the screen went bad. Ordered a replacement LCD screen for it and installed. Everything came on and worked for about 10 minutes again then just a blank screen. IF you turn machine off and wait it will come back on but go blank again like something is getting warm then messing up.
When looking on Internet we found some info that said to be sure to change a parameter to color instead of b/w I guess for it to work but I don't know where that parameter is and what to set for it. I've looked in the books that came with the machine and can't find anything showing the parameter settings. Downloaded the Fanuc TB Lathe Control manual and can't find it there either. Anyone know here it is and what to set it to? Also I'm not sure that will fix it as it seems like a board going bad or something with it working for about 10 minutes then going blank.
I haven't contacted Fanuc yet as I am hoping to figure this out. I'm not really electronically savvy on the boards and stuff but any information would be greatly appreciatedThanks!