[Techbuilder]

I have no clue how to change the cutter comp for each tool
is it in the program or in the parameters?

I looked in the manual but all it says is D for height off set and H for cutter comp
but how do I adjust that?

Any help will be greatly appreciated

[fizzissist]

You better be REAL careful when you press that green button.......At your level, you're playing with fire.

Diameters for offsets are stored in a table, and your program refers to that table at tool change time..... some controls can do it mid-program, but don't assume yours will.

Your tool diameter offset is your "D" word, the length offset is your "H" word. Usually invoked at the time of the tool change, before any movement of the tool...... but...... the tool length offset will be set as the tool actually moves from the tool change position downward.

That's just one reason that you need to be extremely careful about how you invoke your offsets, and be careful about sign and decimals. By the time you hit the big red button, it's too late.