603,923 active members*
3,368 visitors online*
Register for free
Login
IndustryArena Forum > CAM Software > Dolphin CAD/CAM > Lathe dolphin/mach post needed

Thread: Lathe dolphin/mach post needed

Results 1 to 2 of 2
  1. 02-01-2009, 07:38 PM #1
    windy_miller
    windy_miller is offline Registered
    Join Date
    Nov 2008
    Posts
    18

    Lathe dolphin/mach post needed

    Hi all,

    Have got PM level 3 for lathe but it does not come with a post processor for Mach3.

    If anybody has one please could I have a copy. It is pretty useless without. Diameter mode please.

    Cheers,
    Nigel.
    Reply With Quote Reply With Quote
  2. 02-01-2009, 08:20 PM #2
    Dolphin USA
    Dolphin USA is offline Company Representative
    Send a message via AIM to Dolphin USA
    Join Date
    May 2007
    Posts
    428
    Nigel, normally you could go directly to Dolphin UK and get the post since I am assuming that's where you bought you're software. We have no problem helping out though since we all are Dolphin together. If you could email the request to [email protected], we will reply right back the with the Mach 3 post for lathe.
    Dolphin CAD/CAM Support
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Dolphin partmaster mach 3 post processor
    By Goesman in forum Screen Layouts, Post Processors & Misc
    Replies: 3
    Last Post: 02-06-2009, 10:15 PM
  2. Mach 3 + Dolphin CAD/CAM
    By Dolphin USA in forum Dolphin CAD/CAM
    Replies: 0
    Last Post: 01-14-2008, 11:32 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules