I have a Mazak VTC-41 with a EIA/Mazotrol (Yasnac MX3) and the Home Position move .197 or 5mm, The home switch (dog) has no signed that it moved. I had to add .196 to the work offset
What would cause this to happen?
Jim C
I have a Mazak VTC-41 with a EIA/Mazotrol (Yasnac MX3) and the Home Position move .197 or 5mm, The home switch (dog) has no signed that it moved. I had to add .196 to the work offset
What would cause this to happen?
Jim C
If the switch is slow to pop out after coming off the home dog it will go to the next grid back. Check that the switch is not sticking.