I'm getting an alarm on my Meldas 500 controller.
<STOP CODE>
T02 Feed Hold 0204
<ALARM MESSAGE>
Spindle Rotation Malfunction
<OPERATOR MESSAGE>
Check point ! 1.Y2D0.Y2D1 Signa
\ 2. Spdl unit 3. PCL Coil F28
Anybody know what's up. I talked to a tech. He did some troubleshooting and said the spindle controller was OK. He thought something else in the ladder was holding up. Like the probe arm or something. I noticed the probe arm doesn't go down when I give the command. I have to tug on it. It goes back up though when I give the M81
Phoodieman