[mystiks]

Ok, i want your opinion on this argument we seem to have on other thread.

Control is fanuc, and we're talking about cycle G71, and both (Type I/Type II) options installed on machine.

See attachment for profile (Only doing the white profile, ignore the two red lines)

And the profile starts from higher diameter ofc.

My claim was that if you dont give Z-movement on first line after the cycle, it would do the profile with 1 cut. And i'd even remember fanuc's own 2D simulation(Under the graph button) simulating this with 1 cut.

Just write what you think the machine would do in this instance. Thanks