587,683 active members*
3,167 visitors online*
Register for free
Login

Thread: Over travel limit Z question on a HD

Results 1 to 2 of 2
  1. 12-01-2015, 02:23 AM #1
    Pstocky
    Pstocky is offline Registered
    Join Date
    Dec 2015
    Posts
    1

    Over travel limit Z question on a HD

    Everything has been running ok....Changed some tooling and re zeroed the z at the spoil board .... Now when I start the program I get an error NC 118 Negative software overtravel limit Z message and it doesn't move .....Any one have any idea where to start looking for the problem

    Thanks, Paul
    Reply With Quote Reply With Quote
  2. 12-03-2015, 10:58 PM #2
    Montabelli
    Montabelli is offline Registered
    Join Date
    May 2009
    Posts
    281

    Re: Over travel limit Z question on a HD

    I don't know any thing about your controller, but I would check to see if there is a reset limits , or reset soft limits switch in the controller files somewhere
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. How far before the end of travel should I trigger the limit switch
    By bkp08817 in forum Mach Mill
    Replies: 7
    Last Post: 10-26-2012, 03:29 AM
  2. Override travel to get off limit switch...
    By logger in forum Cincinnati CNC
    Replies: 2
    Last Post: 03-01-2012, 05:39 PM
  3. homing limit switch travel
    By tomcorden in forum Mach Mill
    Replies: 1
    Last Post: 12-24-2011, 12:46 AM
  4. Delta 20 travel limit override
    By hawthorne in forum Dynapath
    Replies: 2
    Last Post: 07-19-2011, 03:42 AM
  5. How close to the end of your travel do you have your limit switches?
    By dmgdesigns in forum DIY CNC Router Table Machines
    Replies: 9
    Last Post: 10-28-2005, 01:47 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules