[popspipes]

I would like to know how to shorten the several second delay in conversational facemill?
I dont see any P command after the S3 command?
I am definitely not well versed in G code, nothing I have tried with the P commands changes anything, still have the long delay or it wont accept the command. I need about 2 seconds or so.
I am facing off wood blocks and the long delay takes a lot of time when facing off several of these.

any insight much appreciated!

[popspipes]

I got around the problem by using the plane op in Sprutcam, does basically the same operation, plus I can set zero at the center of the block instead of the corner (easier for me).
Shaved several seconds off the machine time.

I think the setting for the spindle delay must be in pathpilot and not in the conversational facing op.