[BetaBob]

I am in need of the list of M-codes for a Bridgeport VMC 1000 w/ TNC 370 controller. We bought 2 used machines and got very little documentation with them. I've been all over the web but still can't find the codes that control the chip (swarf) conveyor.

Thank You

[gus]

I am not at work, and mine have 410s, but are they possibly in the 'help' m function category?

my other much newer machine uses m7? for on and off conveyor, 72 on and 73 off or 71 and and 72 or something.....

[dmold]

mine has 410 also. under the mod or help key there must be a list of the m codes usedby the machine.

regards
Dimitris

[TheDeon]

I have the same machine and control. And trying to learn to operate the control. However, in the manual mode and if you get to the m code input and press help it will give a list of m codes. Mine was m26, 27, 28. Forward, Off, Reverse respectively.

My problem is I am running a warmup program and try to start the conveyor and it will not startup. Even though my program has an M3 in it. I have to go to the M menu and input the M3 code to run the program. I did try to input the M26 code also and no dice on the conveyor. Any assistance would be greatly appreciated. Thanks