I have two Mori Sieki SL-3A lathes with Fanuc 5T controls.
One is running in inches.
I recently got my backup lathe #2 up and running but it is operating properly in metric mode.
I changed parameter #16 to accept G20 code
Parameter #16 was 0 0 0 0 0 1 0
Changed parameter #16 to 0 0 0 1 0 1 0
Sent an inch program with G20 but the machine still machines in metric mm mode.
I cannot get SL3A #2 to run in inch mode?
What am I doing wrong?