have a question as i always programming in conversation mazatrol but due to lots of people leaving I am now learning the g-code side of it. I have a program that pulls in my cd but when it comes down to its z its 3/4 above the part. I have to tool setup as tool 3 and the length in mazak tool data done by my tool probe. m45 is my indexer code by the way
here is the program at the beginning
O33203
N001
.6CD
G90 G80 G40 G49
G91 G28 Z0.0
G30 X0.0 Y0.0
T03T14M06
M01
G0 G90 G55 X-2.61 Y0.0 S5000 M03
G43 H2 Z.5
M45
G99 G82 Z-.04 R.1 F50.
X-3.36
X-4.11
any help would be great