Hi guys, im very newbie,
trying to figure out a prompt error command:
"Motion Command Exceeds Axis Travel"
any ideas would be greatly appreciated thanks
Hi guys, im very newbie,
trying to figure out a prompt error command:
"Motion Command Exceeds Axis Travel"
any ideas would be greatly appreciated thanks
One idea: maybe this an error in programming a position block, if in conversational mode.
After calibrating the Axis, check the Machine Position displays for X & Z. Write Down the X and Z values. The machine will calibrate on the X and Z + Limit. This is the Max travel you can program in a position block if the Position block has Where = Move to XZ and Reference = Machine Zero. Use the numbers written down above, or something a little less than max travel.
You can also call the Hurco Applications Dept. for assistance.
317-298-2635
Brock
thank you for your help, the problem was during part set up and tool set up. The tool kept working behind the chuck. Like you mentioned I finally got the Z & X position right.