[Haeusser]

In the simulator, is there any way to "tighten" up graphics? Graphics, not tolerances. I will mill a part, -.005 on the ends and it shows yellow, sometimes green. Same thing with some arcs, red in spots and the "zebra" blue green. Any suggestions?


-josh

[inflateable]

In simulator, go into 'options' and choose tolerances and fiddle with the settings in there.

It's supposed to adjust the display as you want, but to be honest it doesn't seem to make much difference!

[Haeusser]

Ive tried that a while back, same results. It seems to work better if you use the "default" tolerances. Still, not the greatest, but far better than other softwares.