Never posted before but have an issue I just can't figure out.
I imported my iges file and the window pops up convert to inches, which I click yes and it loads the program.
My parameters are set to inches but when I put a material box around part it was doing metric so I click the measurement tool and sure enough its running metric.
I check my parameters on the machine tab its set to inches so I rebooted and did every again. in fact twice, still running metric????
Just a beginner and not sure what to do next.
I designed the part in Geomagic Design and its the only time it will not convert to inches and I am stumped.
???Steve