587,790 active members*
3,441 visitors online*
Register for free
Login

Thread: Trying to test control box

Results 1 to 4 of 4

Threaded View

  1. 01-23-2019, 05:21 AM #1
    silverdrgn
    silverdrgn is offline Registered
    Join Date
    Aug 2010
    Posts
    30

    Trying to test control box

    Just finished wiring the control box and prepping for testing. Need some guidance on mach4 setup, can anyone lend some advice.

    So far I have the software installed, the parallel port connected and motors wired for testing. Not sure where in mach4 the breakout board gets setup. At this point I have the hardware connected and software installed but no setup to make them communicate.
    Attached Thumbnails Attached Thumbnails 20190106_221545.jpg  
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules