I have an LB3000EX with and OSP-P300L controller. Every time I try an M110 code and spits out a 2672-01 Alarm-B C-axis sync command format. I look in the book for the alarm diagnosis and its all just jibberish. Now for the weird part, if I restart the machine on the line after the code the C-axis will clamp and do everything as it should. I tried re-running a program that I know has been proven and worked with the M110 and that would alarm out as well. Not sure if this is a parameter issue or machine issue but I've been stuck at the same line of program for 3 days.
N0001 G140
N0002 G00 X50 Z50
N0003 G50 S3000
NAT08
N0100 G00 X50 Z50
N0101 M110
N0102 G94 M146 M15
N0103 X.4515 Z-0.15 T080808
N0104 C0
N0105 G138 C90.
If i start from beginning the program will fault out at line 101, if I restart from line 102 the program will run fine.
Any help is greatly appreciated!