[tjbaudio]

My uncle has had this manual milling machine for a few years but has never had the chance to set it up. It was a trade out for some thing else and came with no info or tooling other than 1 cutter. The name plate says TWS MD-8 N. It is 12 speed (90 to 3000 I think) set via belts. There are 2 ways to move the Z axis, a rough adjustment moves the whole head, and a fine that moves the spindle only. Currently that part does not seam to work but I did not have time to try and figure it out. This unit is about double the size of an X2. I am looking for any info I can find on it. A parts diagram or manual would be great.

Thank you.

[arizonavideo]

You have a Rf-31.

Grizzly sell them under the #G1006

They also have a parts list.

[tjbaudio]

Thank you very much. Knowing those two model numbers yields great results when searching!