[bexprecision]

MAIN LEVEL CONTROLS

• SUB LEVEL CONTROLS

Gcode Panel = CTRL + G

• HOLD = (Any Key / Space Bar) When moving
• Jump to Line = J
• Cancel = L
• Go = G
• Faster Feed = CTRL + Up Arrow
• Slower Feed = CTRL + Down Arrow
• Restart = R
• Start = C
• Step = S
• Continuous = C

Jog Panel CTRL + J

• X AXIS + = CTRL + Right Arrow
• X AXIS - = CTRL + Left Arrow
• Y AXIS + = CTRL + Up Arrow
• Y AXIS - = CTRL + Down Arrow
• Z AXIS + = CTRL + Page Up
• Z AXIS - = CTRL + Page Down
• A AXIS + = CTRL + Plus (+) Key
• A AXIS - = CTRL + Minus (-) Key
• Fast Jog Speed = T
• Medium Jog Speed = D
• Slow Jog Speed = W
• Contunous = O
• 0.1 = O ~ Down Arrow
• 0.01 = O ~ Down Arrow ~ Down Arrow
• 0.001 = O ~ Down Arrow ~ Down Arrow ~ Down Arrow
• Step = E
• Hold = (Any Key / Space Bar) When moving

Point Panel = CTRL + P

• Any Point = SHIFT + 1
• Program Zero = SHIFT + 2
• Machine Zero = SHIFT + 3
• Relative Zero = SHIFT + 4
• Tool Change Position = SHIFT + 5
• Program Start Point = SHIFT + 6
• Current Line Start Point = SHIFT + 7
• Last Feed Hold Point = SHIFT + 8

Home Panel = CTRL + H

• Seek Home = K
• Fast Home = A
• Feed Hold = (Any Key / Space Bar) When moving

Aux Panel = CTRL + A

• Spindle (ON / OFF) = CTRL + 1
• Tool Change (ON / OFF) = CTRL + 2
• Flood Coolant (ON / OFF) = CTRL + 3

MDI Panel = CTRL + M


Probe Panel = CTRL + B


Faster Spindel RPM = ?UNKNOWN?
Slower Spindle RPM = ?UNKNOWN?

Edit Loaded GCODE = CTRL + E
New GCODE File = CTRL + N
Open GCODE File = CTRL + O

[bexprecision]

I poked around with the program and documented what I could. Does anyone know the hotkeys for Speeding up and Slowing down the RPM's for the Spindle ??

[powerr]

i cant find that either. you may have to give them a call. it can be done through their pendant so i would think there would be a key board short cut for it.