Baldor said that the only way their servo drive could run the stainless steel servo motor was with feed back hooked directly to the drive. most of their drives read resolvers but He said that they also will simulate an encoder for feed back to the Galil card. Is this an OK way to run a servo or should I look at Servo Dynamics for a servo drive which will read an encoder?
Thank You
The Farmer
Thread: Feed Back
Results 1 to 2 of 2
-
10-20-2010, 01:53 AM #1
Registered
- Join Date
- Jan 2007
- Posts
- 206
Feed Back
-
10-20-2010, 01:59 AM #2
Community Moderator
- Join Date
- Dec 2003
- Posts
- 24223
With Galil you do not necessarily need intelligent drives, AMC, Copley Controls & Aerotech for example can be used, but the likes of Baldor that require the drive feedback, in your case, resolver, they invariably will output a psuedo differential encoder type output which can be used by the likes of Galil for feedback to the controller.
Often the resolution can be programmed also.
Al.CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
Reply With Quote
Similar Threads
-
new to sit. I would like some feed back on these machines
By cmmi in forum Uncategorised MetalWorking MachinesReplies: 0Last Post: 03-07-2008, 04:06 PM -
Hurco 5M Need feed Back Please
By roadbyte in forum HURCOReplies: 0Last Post: 03-25-2007, 11:10 PM -
Lathe work feed back
By Kool Parts in forum RFQ FeedbackReplies: 0Last Post: 09-27-2006, 02:30 PM
Posting Permissions
