603,373 active members*
3,855 visitors online*
Register for free
Login
IndustryArena Forum > CAM Software > PowerMILL > Vector output pmpost

Thread: Vector output pmpost

Results 1 to 3 of 3
  1. 03-25-2010, 09:03 PM #1
    kidaro2
    kidaro2 is offline
    Join Date
    May 2008
    Posts
    56
    Hello

    I’d like to test the function of tool 3D correction (see http://www.heidenhain.ch/fileadmin/pdb/med.../732_738-11.pdf page 5) at our machine with heidenhain itnc530.

    What should I enter in pm-post under linear movements in order that it would output clauses?

    It outputs LN X Y Z LX LY LZ. The post doesn’t bring any values at LX LY LZ. But I defined that it should output surface normal.

    I hope you know what I mean.

    Regards, daniel
    Reply With Quote Reply With Quote
  2. 03-27-2010, 06:19 PM #2
    Zaaap
    Zaaap is offline
    Join Date
    Oct 2005
    Posts
    24
    Hello Daniel

    Did you set 3D for radius correction in the NC program in PowerMill?

    Greetings
    Zaaap
    Reply With Quote Reply With Quote
  3. 03-28-2010, 10:27 AM #3
    kidaro2
    kidaro2 is offline
    Join Date
    May 2008
    Posts
    56
    No, I didn’t consider the idea of setting it.
    I’ll try it out when I get to the computer
    Thanks
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules