Ooops indeed.
Tweakie.
Ooops indeed.
Tweakie.
CNC is only limited by our imagination.
Yes, oops! Not good.
Was it mechanical damage (impact) or a result of local overheating due to insufficient coolant flow and/or trapped air?
Zax.
That is a bummer.
What was the cause?
Any coolant get into the electronic components?
Hi Guys,
I bought the machine in that condition.
It had an HT fault and I suspect that the service engineer tried to remove the board without first disconnecting the HT cable.
There is no coolant in the part with the electrodes so no water damage - fortunate really.
Tweakie.
CNC is only limited by our imagination.