I work for my family business which is a Machine shop of course. We mainly use Anilam controls but my uncle went to an auction and picked up a little mill with the Dynapath Delta 40 controller. I am a little confused because the people who had it before us had used G code to tell the machine how to run, not by using the event system setting up the nodes, how they did that I have no idea. But that is not my problem. Every time I set it up and program it to run something the cutter comp wont turn on, left, or right or anything. I can set it but it just reads over it or skips it and will mill right down the line I'm trying to comp it for. Any advice would greatly be appreciated!
Results 1 to 2 of 2
-
08-20-2011, 07:14 PM #1
Registered
- Join Date
- Aug 2011
- Posts
- 0
Dynapath delta 40 cutter compensation problems.
-
08-20-2011, 10:07 PM #2
Registered
- Join Date
- Aug 2011
- Posts
- 0
Figured it out
Before anyone posts on this, just thought I'd let you all know I got it figured out. FIANLLY! haha
Reply With QuoteSimilar Threads
-
Cutter compensation problems
By Richster in forum Mach Software (ArtSoft software)Replies: 7Last Post: 07-06-2008, 10:27 AM -
Delta Dynapath 10 problems
By geohot in forum DNC Problems and SolutionsReplies: 4Last Post: 09-06-2007, 03:55 AM -
Delta Dynapath 20 Cutter Comp
By CharlesM479 in forum CNC (Mill / Lathe) Control Software (NC)Replies: 1Last Post: 04-20-2007, 07:52 PM -
Problems with cutter compensation
By randyf1965 in forum Mach Software (ArtSoft software)Replies: 0Last Post: 04-18-2006, 01:14 AM -
Automatic Cutter Compensation problems
By youngfg in forum BobCad-CamReplies: 3Last Post: 03-10-2006, 05:10 PM
Posting Permissions
