[thedudeabidez88]

Hello,

I have been putting together an A2Z/Sherline CNC machine, I'm almost complete with it, I just need to purchase the four stepper motors, four 36 volt drivers, and a 36 volt power supply. I'm looking at Keling drivers and stepper motors. But I'm an beginner, I just want to double check and make sure the power supply is enough to run the amount of motors I'll be using before I purchase the power supply.

I'll be using four NEMA23 282oz/in 3A Stepper Motor ¼” Dual shaft (KL23H276-30-8B) stepper motors, I will be wiring the motors in Bipolar Parallel.

High-Torque Stepper Motor, Stepper Motor, Driver, Stepper Motor kit, DC Servo Motor, DC Servo Motor kit, Stepper Motor Power Supply, CNC Router, Spindle, and other Components. Automation Technology Inc

I'll also be using four KL-4042D Digital Bipolar Stepper Motor Drivers

Stepper Motor Driver Automation Technology Inc

And I'm looking at the 36V/9.7A Switching CNC Power Supply (KL-350-36) from Keling

High-Torque Stepper Motor, Stepper Motor, Driver, Stepper Motor kit, DC Servo Motor, DC Servo Motor kit, Stepper Motor Power Supply, CNC Router, Spindle, and other Components. Automation Technology Inc

[B-RAD]

4042D were out when I ordered, I got 5056D and still use 36v supply. Your good with 282's, I went with 270's

[thedudeabidez88]

Thank you B-rad. I know, I was waiting for awhile on the 4042D's I figured on waiting until they were in stock again, I didnt feel like paying more for the 5056D's. So the 9.7 Amp's would be adequite for the four 3 amp steppers and drivers? I seem to recall its like 1/3 or 1/2 of all the combined motors.