Hello all. My name is Leandro and buy recently an milling machine apollo series 2.

the machine is fully ok but i don have a diskette to boot the software

i find on internet and supouse that the correct software is called DX32 according to the terminal mount on the machine.

inside the door is an PC 286 without HDD only have a diskette drive 3 1/2" and a key put into de LPT port Outside the cabinnet.

can any knows how software i need to put on run mi little baby..?

i can install the DOS and mount an hdd if necesary

please im need to make my first steps in cnc milling .

thanks in advance.
Leandro