587,303 active members*
3,816 visitors online*
Register for free
Login

Thread: Rookie knurling

Results 1 to 4 of 4
  1. 08-30-2012, 01:57 PM #1
    JOE OMNI
    JOE OMNI is offline Registered
    Join Date
    May 2012
    Posts
    0

    Rookie knurling

    Putting a 96 diametral pitch straight knurl on 1.31 diameter 4130 steel. Only about .4 down in Z any tips?? Bump knurl?? Okuma multus b300
    Reply With Quote Reply With Quote
  2. 09-27-2012, 12:50 AM #2
    Kenny0529
    Kenny0529 is offline Registered
    Join Date
    Sep 2012
    Posts
    0
    Are you looking for help with the program portion? Or blank diameter and setup etc???
    Reply With Quote Reply With Quote
  3. 09-27-2012, 10:42 AM #3
    JOE OMNI
    JOE OMNI is offline Registered
    Join Date
    May 2012
    Posts
    0
    All set. Used convex knurling wheel. 350 rpm. Feedrate of .008/rev. Looks nice
    Reply With Quote Reply With Quote
  4. 09-27-2012, 11:47 AM #4
    Kenny0529
    Kenny0529 is offline Registered
    Join Date
    Sep 2012
    Posts
    0
    Ok. If you ever have knurling questions just let me know. I work at a knurling company.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Knurling
    By vbundy in forum MetalWork Discussion
    Replies: 2
    Last Post: 01-08-2010, 09:38 PM
  2. Knurling with V9
    By DublJ in forum Mastercam
    Replies: 1
    Last Post: 01-05-2008, 03:31 AM
  3. Cut Knurling??
    By PoiToi in forum MetalWork Discussion
    Replies: 2
    Last Post: 09-15-2007, 06:30 PM
  4. Knurling
    By SPEEDRE in forum MetalWork Discussion
    Replies: 4
    Last Post: 10-03-2006, 12:04 PM
  5. Knurling ?
    By Ken_Shea in forum MetalWork Discussion
    Replies: 13
    Last Post: 02-23-2004, 05:17 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules