[mrpackethead]

Hi, I have run into a bit of a problem; i ahve no idea how the stepper motors should be wired to by drives.

I bought a kit from automotion technologies.. Its got 2 x KL23H286-20-8B motors, drives are KL5042, and 1 x LK34H295_43_8A driven by LK-8060.

The documentation is almost non existent, only a couple of schematics that dont' make too much sense.

I have some datasheets for the motors, so i can work out the wiring from those..

whats the normal way of wiring them up, Bipolar(parrallel) / Bipolar(Series) or Unipolar ?

[automationtechinc]

Hi Sir

Pls use these wiring diagram. most use this one

http://www.automationtechnologiesinc...042WithC10.pdf

http://www.automationtechnologiesinc...H286-20-8B.pdf

http://www.automationtechnologiesinc...H295-43-8A.pdf

wire them as Bipolar(parrallel)

if you have question, pls let us know

Automation Technology Inc. | Stepper Motors, Servo Motors, CNC Stepper Motors, Stepper Drivers, CNC Kits, Stepper Kits Automation Technology Inc

[mrpackethead]

Kellinginc, The diagram withC10 shows incorrect wiring colours for the motors. The PdF's for the motors, are confusing because there are two different wiring guides. Never the less I managed to figure the motor to drives out, but it needs to be tidied up, becuase its very confusing.

And it did ask you a question, and your reponse was..


"Hi Andrew
we sell this every day
every one get it working based on what we have
You just need to understand it"

Great support.. NOT!!!!

Hi Sir

Pls use these wiring diagram. most use this one

http://www.automationtechnologiesinc...042WithC10.pdf

http://www.automationtechnologiesinc...H286-20-8B.pdf

http://www.automationtechnologiesinc...H295-43-8A.pdf

wire them as Bipolar(parrallel)

if you have question, pls let us know

Automation Technology Inc. | Stepper Motors, Servo Motors, CNC Stepper Motors, Stepper Drivers, CNC Kits, Stepper Kits Automation Technology Inc